OBD-II · Motor a hnacie ústrojenstvo (P)
P2453
DPF pressure sensor A circuit range/performance
Čo znamená
The DPF differential pressure sensor measures the pressure difference across the particulate filter through two hoses. The engine computer uses it to estimate how full the filter is. This code means the reading does not make sense for how the engine is running - most often a hose problem rather than a wiring fault.
Príznaky
- engine warning light
- DPF regeneration may not run or may run too often
- possibly reduced power (limp mode)
Pravdepodobné príčiny, od najčastejšej
| No. | Príčina |
|---|---|
| 01 | split, disconnected, blocked or swapped sensor hoses |
| 02 | failed differential pressure sensor |
| 03 | water or soot in the sensor hose |
| 04 | genuinely blocked or damaged DPF |
| 05 | exhaust leak before the DPF |
Čo skontrolovať, krok za krokom
- 01With the exhaust cool, inspect hoses and pressure tappings for splits, blockage and correct routing. Disconnect hoses from the sensor before cleaning them according to the maker's procedure; never blow compressed air into the sensor.
- 02Read the sensor with engine off (near zero) and at idle and 3,000 rpm; pressure should rise with rpm.
- 03Check for exhaust leaks before the DPF.
- 04Replace the sensor if hoses are good and readings are implausible.
- 05If readings are plausible but high, investigate the DPF load (P2463/P242F).