OBD-II · Engine and powertrain (P)
P0336
Crankshaft position sensor A range/performance
What it means
The crankshaft signal has missing or extra pulses or does not match the expected pattern.
Symptoms
- engine cranks but will not start
- engine cuts out, often when hot, and may restart after cooling
- rev counter drops to zero or jumps
- engine warning light
Likely causes, most likely first
| No. | Cause |
|---|---|
| 01 | damaged or loose trigger wheel teeth |
| 02 | metal debris on the sensor tip |
| 03 | incorrect sensor gap or loose sensor |
| 04 | electrical interference from ignition or charging wiring |
| 05 | failing sensor |
What to check, step by step
- 01Inspect the sensor connector and wiring, which is often routed near hot or moving parts
- 02Watch the engine speed in live data while cranking: no rpm signal points to the sensor or wiring
- 03Identify the sensor type first: resistance-test only an inductive sensor to specification. For Hall sensors, test supply, ground and waveform; do not use an ohmmeter.
- 04Remove the sensor and check its tip for metal debris or damage, and the trigger wheel for damaged teeth
- 05Replace the sensor if the wiring is good